DOC vehicle decal  
installation guide
Step 1:
Clean the area thoroughly 
using either IPA alcohol 
or soap and water. 
Do not use cleaners or 
similar products because it 
will leave a residue behind 
that will prevent the decal 
from adhering well. 
Step 2:
Peel the paper backing off 
the decal.
Step 3:
Slowly lower the decal onto 
200 mm
the surface and rub it in 
place firmly with a squeegee 
The sign starts 
at the door  
or credit card. 
handle and 
finishes at the 
The decal has a special air 
body crease/
moulding.
release backing so any air 
pockets trapped under it 
should smooth out when 
Width of sign varies according to door size. 
Centre corporate signature on front door panel.
rubbed with a squeegee.
The decal is supplied at 1300 mm x 200 mm. 
Trim off excess if too long and smooth down edges.
The decal should be applied to both front doors.

---